MacBook Won't Turn On: What to Try Before a Repair
You open the lid, press the power button, and nothing. No chime, no logo, no keyboard light. Or the MacBook makes a sound but the screen stays black. Before you assume the logic board is gone, run through the checks below. Many “dead” MacBooks turn out to be a drained battery, a bad charger or a Mac that is on but not showing a picture.
First, figure out which of three situations you are in:
- Completely dead: no sound, no light, no heat, nothing.
- On, but black screen: you hear a chime or fans, the keyboard lights up, or Caps Lock toggles its light, but there is no image.
- Starts but does not finish: you see a logo, a folder with a question mark, a circle with a line through it, or it restarts over and over.

In this guide 6 sections
If it seems completely dead
Check the charger and the outlet
- Plug the charger into a wall outlet you know works, not a power strip.
- If your MacBook uses MagSafe, look at the light on the connector. Amber means charging, green means full. No light means no power is reaching the Mac.
- With USB-C, try the other ports. Some MacBooks charge from any USB-C port, and one port can fail while the others still work.
- Try a different charger of the right wattage if you can borrow one. Phone chargers are too weak to start a MacBook with an empty battery.
Leave it charging for at least 30 minutes with the lid open, then try the power button again. A fully drained battery may need that long before the Mac will start.
Force restart
Press and hold the power button (Touch ID button on newer models) for 10 seconds, let go, wait a few seconds, then press it once.
Reset power management on Intel MacBooks
If your MacBook has an Intel processor, resetting the SMC can bring back a Mac that ignores the power button. On models with the T2 chip (most from 2018 to 2020), shut down, then press and hold Control, Option and Shift on the left side for 7 seconds, add the power button, hold all four for 7 more seconds, release, and turn it on. Apple silicon MacBooks (M1 and later) do not have this reset. On those, the forced restart above does the same job.
If it is on but the screen is black
- Press the brightness up key several times. Brightness at zero looks exactly like a dead screen.
- Connect an external monitor or TV. If you get a picture there, the Mac is working and the problem is the display or its cable. See MacBook screen repair.
- Shine a flashlight at an angle on the screen. A very faint image means the backlight has failed, which is a display or board fault.
Rather have us fix it?
Free diagnostic, walk-ins welcome at 6201 Greenback Ln Suite A, Citrus Heights.
If it starts but does not finish
A flashing folder with a question mark means the Mac cannot find its startup disk. A circle with a line through it, or a restart loop, usually means macOS is damaged.
Start in recovery mode:
- Apple silicon: shut down, then press and hold the power button until you see “Loading startup options”. Choose Options.
- Intel: turn it on and immediately hold Command and R until you see the Apple logo.
From there you can run Disk Utility, First Aid on the internal drive, and then use Reinstall macOS. Reinstalling macOS over the top keeps your files, but make sure you choose reinstall, not erase.
If you have a second Mac, Apple’s support site explains how to revive the firmware of an Apple silicon MacBook using Apple Configurator. Revive keeps your data. Restore erases it, so read the steps carefully.
Signs it is a hardware problem
- It stopped after a spill. Even a small amount of liquid can short the board. Do not keep trying to turn it on. Our guide on MacBook liquid spills explains what to do and our liquid damage page covers the repair.
- The trackpad got hard to click or the bottom case bulges. That is a swollen battery. Stop charging it and bring it in. See MacBook battery replacement.
- It only runs while plugged in, or dies at a high percentage. The battery is worn out.
- The charger works on another Mac but this one gets no power in any port. That points to the charging circuit on the logic board.
- It gets warm while it seems off. Something on the board is drawing power it should not.
Your files
On modern MacBooks the storage is soldered to the logic board. If the board fails, your files go with it unless the board is repaired. That is a reason to repair rather than replace the board when you do not have a backup, and a reason to turn on Time Machine or iCloud Drive once the Mac is running again.
MacBook repair in Citrus Heights
RepairHub at 6201 Greenback Ln Suite A in Citrus Heights repairs MacBook Air and MacBook Pro models that will not start. The diagnostic is free and walk-ins are welcome. Bring the MacBook and its charger, and tell us whether there was a spill or a drop.
More details are on our MacBook repair page. For an estimate, open the repair calculator with MacBook not booting selected.
